Justin Pate, of The Wrap Institute, highlights how great the Restyler Ramp is for car wrap installers – it is a portable, lightweight ramp system that can be used in the shop as well as on-the-go to other job locations.
The Restyler Ramp is the perfect back and time saver for wrap shops and installers – especially when working on low clearance vehicles. No more worming around on the ground!
Safely and easily lift your vehicle up 14″ for vinyl wrapping, detailing, installing paint protection, display, or maintenance with our Restyler Magna Ramps. Featuring an angle of approach of 10.36 degrees, the ramp system is available in a 16″ width (for tires up to 14″ wide) and a 20″ width (for tires up to 18″ wide). The system accommodates wheelbases from 82″ to 128″.
Each Restyler Ramp consists of five interlocking pieces that combined weigh only 110 lbs., with no one piece weighing more than 40 lbs. Once the car is safely on the blocks, the center “bridge” piece can be removed from each side for easier access underneath the car – or for use as a bench or step stool for more convenient access to the whole vehicle. The incline portion can also be removed for greater accessibility around the car. For ultimate ease loading and unloading, you can purchase a second set of inclines for the 16″ width to place at the front of the ramp setup, allowing you to smoothly drive up and down on both ends without needing to move any inclines.
The 16″ option comes in both red and black. All variations include steel strips built into the ramp for directly holding magnetic tools and/or a magnetic shelf.
The ramp system has a total vehicle weight capacity of 6,000 lbs. and comes with one pair of inclines. For either width, an additional set of inclines is available that will interlock to the front and enable a vehicle to smoothly drive up and down both ends. This convenient and portable setup is great for use in the shop as well as when you’re on-the-go to other job locations. Watch all these great features in action in the video to the left by Justin Pate of The Wrap Institute.
If you’re working with cars really low to the ground (Lamborghinis and Ferraris!), the optional XTenders will decrease your angle of approach to only 6.8 degrees, allowing you to work on virtually any car without banging up its nose.
- APPROACH ANGLE
- WEIGHT CAPACITY
- MULTI PIECE
- QUANTITY2 ramps
- WEIGHT220 lbs. total
- APPROACH ANGLE10.36 degrees
- WHEELBASE82" to 128"
- WEIGHT CAPACITY6,000 lbs. per set
- MULTI PIECE5 per side
- WEIGHT280 lbs. total
- APPROACH ANGLEsame
- WEIGHT CAPACITYsame
- MULTI PIECEsame